Sound Masking Systems
Open floor plans trade walls for distraction. Sound masking raises the background level just enough that nearby conversations stop being intelligible, and nobody notices the system is running.
Sound masking is not white noise turned up. It's a shaped spectrum spread evenly across a space so speech from a few desks away blends into the background instead of pulling your attention off your work.
We lay emitters out on a grid suited to the ceiling, cable and zone them, then tune the system in the finished space. Done properly, staff notice fewer distractions and private conversations stay private.
What you get
- Conversations two or three workstations away stop being intelligible
- Even coverage, with no loud or dead spots as you walk the floor
- Zones tuned separately for open areas, offices, and corridors
- Optional paging and background music on the same distribution
- Tuning done after the furniture and ceilings are actually in
What we install and support.
Emitter layout
Grid spacing planned around ceiling type, height, and floor plan.
Masking curve tuning
Spectrum shaped and verified with a meter in the finished space.
Zoning & levels
Separate levels for open areas, private offices, and corridors.
Paging & music integration
Shared distribution with overhead paging and background audio.
Speech-privacy focus
Designed around cutting intelligibility, not just adding noise.
Post-install walkthrough
Levels re-checked once the space is occupied, then adjusted.
Where this work belongs.
We work across commercial property types throughout Tampa Bay and Florida. If your building type isn't listed here, call and ask.
A repeatable process, from walk to handoff.
Assess the space
Ceiling type, layout, partition heights, and privacy concerns reviewed.
Design the grid
Emitter spacing and zone boundaries mapped for even coverage.
Plan the head end
Generator, amplifier, and control location picked with paging in mind.
Install
Emitters mounted above or in the ceiling and cabled to the head end.
Tune
Spectrum and level set per zone, with measurements across the floor.
Re-check
Adjusted once the space is occupied and furnished.
Details that matter on site.
Ramp it in, don't switch it on
Masking works best when nobody notices it. Levels usually come up gradually over several days so people acclimate. A system commissioned at full level on day one is the one that generates complaints, even when the spectrum is correct.
Plenum vs. direct-field emitters
Plenum emitters fire up into the deck and let the ceiling diffuse the sound, which works well over a standard tile grid. Open plans, hard decks, and high ceilings usually need direct-field emitters aimed down, since there's no plenum to diffuse through.
What clean installs look like.
Representative equipment and examples of the systems our team installs and supports.
Often paired with this work.
Serving Tampa Bay and surrounding Florida markets.
We're based in Tampa and travel to job sites throughout the bay area and across Florida. If your project is in the region, we can be on site.
View all service areasPlanning a Low-Voltage Project?
Tell us about the site, scope, and schedule. We'll walk through the requirements and get you a clear, honest quote.